Fine Controls (UK) Ltd - Landon Kingsway

IMAGE	MODEL	DESCRIPTION	RESOURCES
	LK-GSP4	LANDON KINGSWAY LK-GSP4 - GAS DETECTION SYSTEM The IP54/Sensor 10 heads should be mounted either on a vertical wall or on the ceiling facing downwards, this is so dust does not settle on the sensor vent. Electrical connection is made to terminals inside the sensor. When the remote sensor or sensors detect the presence of the target gas (Natural, Carbon Monoxide or LP) a signal will be sent back to the panel, the panel then sends a signal to close the gas solenoid valve shutting off the gas supply. The panel will then indicate which zone is in alarm. Once the problem has been rectified the reset button is pressed and the panel should indicate zone on. If there is still gas present in the area (zone) the panel will go into alarm once again. • LED Design • Natural gas detector • LPG detector • Carbon Monoxide detector Contact us about this product	PDF Datasheet
	LK-GMS	LANDON KINGSWAY LK-GMS - GAS PROVING SYSTEM The LKGMS controller is a fully automatic pressure proving system that will check out pipework and determine if there is a system leak. Typical installations would be 27mBar and 38mBar systems. The control panel will when turned on, energise the gas supply valve for a short period of time and then perform a series of tests on the pressure in the pipework. From the result of these tests the control panel will declare the pipework leak-tight or not. This is indicated by one of two lights on the control panel. If the pipework is declared leak-tight, then the gas supply valve is energised. • Supply Voltage 230V AC • Power 30VA + valve • Protection Rating IP54 • Temperature range -10°C to +50°C Contact us about this product	PDF Datasheet

IMAGE

MODEL

DESCRIPTION

RESOURCES

LK-GSP4

LANDON KINGSWAY LK-GSP4 - GAS DETECTION SYSTEM

The IP54/Sensor 10 heads should be mounted either on a vertical wall or on the ceiling facing downwards, this is so dust does not settle on the sensor vent. Electrical connection is made to terminals inside the sensor. When the remote sensor or sensors detect the presence of the target gas (Natural, Carbon Monoxide or LP) a signal will be sent back to the panel, the panel then sends a signal to close the gas solenoid valve shutting off the gas supply. The panel will then indicate which zone is in alarm. Once the problem has been rectified the reset button is pressed and the panel should indicate zone on. If there is still gas present in the area (zone) the panel will go into alarm once again.

• LED Design

• Natural gas detector

• LPG detector

• Carbon Monoxide detector

PDF Datasheet

LK-GMS

LANDON KINGSWAY LK-GMS - GAS PROVING SYSTEM

The LKGMS controller is a fully automatic pressure proving system that will check out pipework and determine if there is a system leak. Typical installations would be 27mBar and 38mBar systems. The control panel will when turned on, energise the gas supply valve for a short period of time and then perform a series of tests on the pressure in the pipework. From the result of these tests the control panel will declare the pipework leak-tight or not. This is indicated by one of two lights on the control panel. If the pipework is declared leak-tight, then the gas supply valve is energised.

• Supply Voltage 230V AC

• Power 30VA + valve

• Protection Rating IP54

• Temperature range -10°C to +50°C

PDF Datasheet

Displaying 1 to 2 (of 2 products)